Express5800/Ft Series Service Program Configuration; Service For Ft Server Operation In Duplexed Mode; Service For Monitoring The Server And Notification - NEC Express5800/R320g-M4 Maintenance Manual

Chapter 2 Configuring and Upgrading the System
4.

Express5800/ft Series Service Program Configuration

This section explains about service programs necessary for Express5800/ft server operation.
There are notices as follows about service programs used by ft server.

Several service programs depend on other service. Don't also stop those service programs which depend.
(Service names which depend: Remote Access Connection Manager, Remote Procedure Call (RPC) and
Telephony, etc.)

.NET Framework and Visual C++ library (Microsoft Visual C++ Redistributable) are installed together with ft
Server Control Software when setting up this server.
These components are required for operating service programs dedicated to ft server. Do not uninstall them.
4.1

Service for ft server operation in duplexed mode

The following services are necessary for ft server operation in duplexed mode. Do not stop these services.
Service names shown in [Services]
ftSys eService
ftSys Maintenance and Diagnostics (MAD)
ftSys RPC Provider
ftSys SSN
ftSys RAS
Virtual Disk(vds)
Windows Management Instrumentation
To reduce the load when the system starts, the services which Startup Type are "Manual" in above start
automatically 5 minutes later after the system starts. Even if Startup Type is changed, it will be returned to
"Manual".
4.2

Service for monitoring the server and notification

When minimizing the number of operating services temporarily is required, the following services can be
stopped: Make sure to restart the operations of stopped services immediately after the backup processes are
completed.
Although these services are stopped and ft server continues operation in duplexed mode, monitoring the duplex
mode and notification based on the result of monitoring cannot be performed.
Service names shown in [Services]
Alert Manager Main Service
ESMBmcConfigMonitoring
ESMCommonService
ESMFSService
ESMPS
ESRAS Utility Service
SNMP Service
To reduce the load when the system starts, the services which Startup Type are "Manual" in above start
automatically 10 minutes later after the system starts. Even if Startup Type is changed, it will be returned to
"Manual".
Express5800/R310g-E4, R320g-E4, R320g-M4 Maintenance Guide (Windows)
146
4. Express5800/ft Series Service Program Configuration
Startup Type / Function which dedicated to ft server
Manual / Outputs SEL (System Event Log).
Manual / Provides ft control management and diagnostics functions.
Manual / Manages WMI configuration and status.
Manual / Controls communications between modules.
Manual / Controls communications between modules.
Automatic
Automatic
Startup Type / Function which dedicated to ft server
Manual
Manual
Manual
Manual
Manual / Monitors the duplexing state, and outputs event log.
Manual
Manual