NEC Express5800/R320g-M4 Maintenance Manual page 130

Chapter 2 Configuring and Upgrading the System
(d) Resynchronize This Physical Disk From RDR Virtual Disk
Disks whose synchronization by RDR is cancelled can be resynchronized.
1. Click Start – RDR – RDR Utility to start RDR Utility.
2. Right-click a target disk in the left pane and click Resynchronize This Physical Disk From RDR Virtual
Disk.
3. In the Resynchronize This Physical Disk From RDR Virtual Disk dialog box, click OK.
4. Confirm that the resynchronization starts and the status of disks changes as shown below:
Resynchronizing
Source disk
Destination disk
RDR Virtual Disk
Synchronization completed
Source disk
Destination disk
RDR Virtual Disk
Express5800/R310g-E4, R320g-E4, R320g-M4 Maintenance Guide (Windows)
130
DISK ACCESS LED
Blinking amber and green
Blinking amber and green
–
DISK ACCESS LED momentarily lights green when disk is accessed. If the disk is
Tips
accessed while the amber LED is blinking (during synchronizing), the LED seems to light
green and amber alternately.
DISK ACCESS LED
unlit
(Lights green when
accessing the disk drive)
unlit
(Lights green when
accessing the disk drive)
–
DISK ACCESS LED is lit green only when hard disk drive is accessed.
Tips
If no access is made, the LED seems to be unlit.
1. Hard Disk Drive Operations
RDR Utility
Op State: State Status
Simplex
Syncing
Resync x %
Simplex
(x=0,4,8,･･･96)
RDR Utility
Op State: State Status
Duplex
Duplex
Duplex None
–
–
–
–