Setting The Port Operating Mode - Cabletron Systems SmartSwitch 6E122 Supplement Manual

PORT STAT. (Toggle)
Used to enable (turn on) or disable (turn off) the port. To set the port to
operating mode, refer to
SET ALL PORTS (Selectable)
Used to select operating mode for all the ports on the connector
simultaneously. This field steps through the following selections:
Auto-Neg., 10Base T, and 100Base-TX. To set all ports to the same
operating mode, refer to
CONNECTOR # (Selectable)
Selects the front panel connector to which the settings will be applied.
3.2.1

Setting the Port Operating Mode

To set the operating mode for one or more repeater ports, proceed as
follows:
1. Use the arrow keys to highlight the CONNECTOR # field.
2. Use the SPACE bar to step to the appropriate connector number.
3. Press RETURN to display the settings for the selected connector.
4. Use the arrow keys to highlight the DESIRED OPER. MODE field
of the port being configured.
5. Use the SPACE bar to step to the appropriate Operating Mode
(Auto-Neg, 10Base-T, or 100Base-TX).
6. If setting the operating mode on other ports, repeat steps 2 to 5 for each
one and then proceed to step 7.
7. Use the arrow keys to highlight the SAVE command.
8. Press ENTER. The message "SAVED OK" displays and all operating
mode settings are saved.
Local Management Supplement
Repeater Port Configuration Screen
Section 3.2.2.
Section 3.2.3.
3-5