Network Tools - Cabletron Systems SmartSwitch 6E122 Supplement Manual

Chapter 1: Changes to Local Management Screens
1.27

NETWORK TOOLS

This section introduces the "cdp" command, which is a new addition to
the built-in commands listed in the SmartSwitch User's Guide.
The Network Tools function resides on the platform firmware and allows
the user to access and manage network devices.
updated Network Tools Help screen.
To access the Network Tools screen, access Local Management, then use
the arrow keys to highlight the NETWORK TOOLS menu item in the
Module Menu screen and press ENTER. The Network Tools screen
displays.
Type help at the prompt to list all the commands that are
available for the device in the current operational mode. A
TIP
command used incorrectly (wrong syntax) will prompt a display
of the correct usage. Use lower case characters when entering
commands in Network Tools.
Welcome to Network Tools
-> help
Commands Available to the User:
Built in Commands:
bridge
arp
netstat ping
show traceroute
soft_reset telnet
atm_stp_state cdp
SPECIAL:
done, quit, or exit - Exit from the Network Tools.
For help with a specific command, type 'help <command>'.
->
1-70
defroute
reset
link_trap
stpStandby
Figure 1-26 Network Tools Help Screen
Figure 1-26
Local Management Supplement
shows the
090829