Important Information - GE EST iO64 Technical Reference Manual

Important information

Limitation of liability
This product has been designed to meet the requirements of NFPA
72 National Fire Alarm Code, UL 864 Standard for Control Units for
Fire Protective Signaling Systems, and ULC S527 Standard for Control
Units for Fire Alarm Systems. Installation in accordance with this
manual, applicable codes, and the instructions of the authority
having jurisdiction is mandatory. GE Security shall not under any
circumstances be liable for any incidental or consequential
damages arising from loss of property or other damages or losses
owing to the failure of GE Security products beyond the cost of
repair or replacement of any defective products. GE Security
reserves the right to make product improvements and change
product specifications at any time.
While every precaution has been taken during the preparation of
this manual to ensure the accuracy of its contents, GE Security
assumes no responsibility for errors or omissions.
iO64 and iO500 FCC compliance
This equipment can generate and radiate radio frequency energy. If
the equipment is not installed in accordance with this manual, it
may cause interference to radio communications. This equipment
has been tested and found to comply with the limits for Class A
computing devices pursuant to Subpart B of Part 15 of the FCC
Rules. These rules are designed to provide reasonable protection
against such interference when this equipment is operated in a
commercial environment. Operation of this equipment is likely to
cause interference, in which case the user, at his own expense, will
be required to take whatever measures may be required to correct
the interference.
SA-DACT FCC information
Cautions
• To ensure proper operation, this dialer must be installed
according to the enclosed installation instructions. To verify that
the dialer is operating properly and can successfully report an
alarm, it must be tested immediately after installation, and
periodically thereafter, according to the enclosed test
instructions.
EST iO64 and iO500 Technical Reference Manual iii