GE EST iO64 Technical Reference Manual page 120

Chapter 3: Programming
number (up to 20 digits).
Secondary receiver number: Enter the secondary receiver's
phone number (up to 20 digits).
Format: CID
CID: Contact ID is the alarm format that the monitoring facility
(DACR) will receive. See "Contact ID event codes" for more
information.
Event notification: Set event notification (event reporting) to:
Device: Only device information is reported/transmitted, no
zone information. Note: This setting uses default device event
notification settings for reporting events. Refer to "Factory
default settings" for more information.
Zone: When a device is a member of a zone, only the zone
information is reported/transmitted, no device information.
Note: This setting uses default zone event notification settings
for reporting events. Refer to "Factory default settings" for
more information.
Event: Only the event type (alarm, supervisory, trouble, etc.) is
reported/transmitted, no device or zone information. Note:
This setting uses the default CMS event notification settings
for reporting events. Refer to "Factory default settings" for
more information.
NET options programming
Enter the central monitoring station (CMS) account's six-digit ID
Account ID
code.
IP Enter the IP address for the CMS.
Event Set event notification (event reporting) to:
notification
Device: Only device information is reported/transmitted, no
zone information. Note: This setting uses default device event
notification settings for reporting events. Refer to "Factory
default settings" for more information.
Zone: When a device is a member of a zone, only the zone
information is reported/transmitted, no device information.
Note: This setting uses default zone event notification settings
for reporting events. Refer to "Factory default settings" for
more information.
Event: Only the event type (alarm, supervisory, trouble, etc.) is
reported/transmitted, no device or zone information. Note:
This setting uses the default CMS event notification settings
for reporting events. Refer to "Factory default settings" for
more information.
Receiver Enter the CMS receiver number. Specifies the CMS receiver
number number that you want displayed in the message sent to the
receiver. This number is user-defined.
Line number Enter the CMS receiver line number. Specifies the receiver's line
number that you want displayed in the message sent to the
receiver. This number is user-defined.
110
Network
Account ID
IP 000.000.000.000
Event Notif.
⇩
Network
Receiver#
Line#
Save
EST iO64 and iO500 Technical Reference Manual
676968
Event>
000
000