GE EST iO64 Technical Reference Manual page 108

Chapter 3: Programming
3. Choose Programmable Keys.
4. Enter the level two password.
5. Choose the key you want to program (Key #1 or Key #2).
6. Choose New List.
Note: If the key is already programmed, you can choose Edit
List to reprogram the key. Edit only allows you to add or remove
NACs, devices, or zones; it does not allow you to change the
type of operation (e.g. disable to enable).
Note: If the key is currently active (pressed), "Key is active" is
displayed and you cannot program the key until it is
deactivated.
7. Select Controls.
8. Choose one of:
Panel NAC: Programs the key to enable, disable, activate, or
restore panel NACs.
Device: Programs the key to enable, disable, activate, or restore
a single device or multiple devices.
Zone: Programs the key to enable or disable zones.
9. Select Operation.
10. Choose either En/Dis or Act/Res.
Note: If you selected Zone above, you can only select enable or
disable for operation.
11. Press Enter.
Either the panel NAC, device, or zone "add" screen is displayed
depending on what you picked in step 8.
12. Add the panel NAC, device, or zone that you want the key to
control using the following:
Panel NAC: Select the NAC (number) that you want to add and
press Enter. The NAC number will automatically increment to
the next NAC number so that you can quickly add all desired
NACs. If the NAC is already added, "remove" is displayed
indicating that you can only remove the NAC, not add it. When
finished, press Back. Go to step 13.
Device: Select the loop (number) the device is on, and then
select the device (number) that you want to add and press
Enter. If you select an input device "invalid device" is displayed,
meaning you cannot add an input device. The device number
will automatically increment to the next device number so that
i kl dd ll d i d d i
98
If h d i i l d
EST iO64 and iO500 Technical Reference Manual
Program
Unattended Dnld
Laptop Enable
Programmable Keys
⇩
Enter Password
0000
⇩
Programmable Keys
Key #1
Key #2
⇩
Key #1
Edit List
New List
Save
⇩
Key #1
Controls Panel NAC>
Operation En/Dis>
⇩
Enter to Add<>
Panel NAC
NAC 1
<Back <Enter
-OR-
Enter to Add<>
Zone 01
Zone 1
<Back <Enter
-OR-
Device
Loop 01<>
⇩
Enter to Add<>
Device 001
Loop 1 Device 1
<Back <Enter
⇩
Enter to Add<>
Device 001
Loop 1 Device 1
<Back <Enter
⇩
1