Table of Contents
Advertisement
lsSdlcLlc2OperTable (portSdlcGroup.6)
This table contains Read only variables that reflect the actual operating parameter
values. Unless a value was changed in the
became operational, the values in the
figured in the
lsSdlcLlc2AdminTable
below.
lSSdlcLlc2OperLocalSap (lsSdlcLlc2OperTable.1.1)
lSSdlcLlc2OperLocalMac (lsSdlcLlc2OperTable.1.2)
lSSdlcLlc2OperIdblk (lsSdlcLlc2OperTable.1.3)
lSSdlcLlc2OperIdnum (lsSdlcLlc2OperTable.1.4)
lSSdlcLlc2OperLanTi (lsSdlcLlc2OperTable.1.5)
lSSdlcLlc2OperLanT1 (lsSdlcLlc2OperTable.1.6)
lSSdlcLlc2OperLanT2 (lsSdlcLlc2OperTable.1.7)
lSSdlcLlc2OperLanN2 (lsSdlcLlc2OperTable.1.8)
lSSdlcLlc2OperLanN3 (lsSdlcLlc2OperTable.1.9)
lSSdlcLlc2OperLanTw (lsSdlcLlc2OperTable.1.10)
lSSdlcLlc2OperBAG (lsSdlcLlc2OperTable.1.11)
lSSdlcLlc2OperPriority (lsSdlcLlc2OperTable.1.12)
lSSdlcLlc2AdminSuppressXID
portT1Group (port.7)
portT1AdminTable (portT1Group.1)
portT1AdminBlockedPortFlag
STATUS:
ACCESS:
STATUS:
DESCRIPTION: Flag which when set, means the port will not be enabled
::= {portT1AdminTable.1.1}
portT1AdminGenerateClock
STATUS:
ACCESS:
STATUS:
DESCRIPTION:Determines whether the port will generate the clock
::= {portT1AdminTable.1.2}
60
lsSdlcLlc2AdminTable
lsSdlcllc2OperTable
. The variables in the
(lsSdlcLlc2OperTable.1.13)
INTEGER {no (
), yes (
1
read-write
Mandatory
after a boot-up of the node.
INTEGER {no (
), yes (
1
read-write
Mandatory
necessary to synchronize traffic over the link.
after the interface
should match those con-
lsSdlcLlc2OperTable
)}
2
) }
2
Cabletron Relay Access Products
are listed
Advertisement
Table of Contents
