Table of Contents
Advertisement
::= { portDLCIConfigTable.1.13 }
portDLCIBackupProtEnb
SYNTAX:
ACCESS:
STATUS:
DESCRIPTION:specifies that (if enabled) this DLCI will be used as a
::= { portDLCIConfigTable.1.14 }
portFrBackupGroupTable (portFrGroup.3)
This table defines frame relay backup groups. A backup group is one or more DLCIs
that can act as a backup for one or more "primary" DLCIs. If a node detects a failure in
a primary DLCI connection, the software will search the backup group configured for
the primary DLCI, and will select the first available DLCI in that group as a backup.
The backup will become operational and will remain in that state until the primary
becomes active again. If the backup fails while in use, the software will check the status
of the primary, then (if necessary) search the primary's backup group for another
backup.
portFrBackupRLP
SYNTAX:
ACCESS:
STATUS:
DESCRIPTION:FRX6000 or FRM RLP containing the primary and
::= { portFrBackupGroupTable.1.1 }
MIB Reference
A DLCI cannot be both a backup and a primary.
Also, on an FRX6000 or FRM, the primary and
all backups must be on the same RLP, or a PVC
must be configured between the DLCIs.
Do not configure a Backup Group
Number on this DLCI at the remote (non-
initiating) end.
INTEGER { disable (
1
Read/Write
Mandatory
non-initiating backup. The DLCI will wait for a backup
protocol message from the initiating end, telling the
backup where to send the rest of the messages.
INTEGER (
, which correspond to actual RLP numbers
1–8
)
0–7
Read only
Mandatory
backup DLCIs. The value is irrelevant on a SmartSwitch
1800 or FRX4000.
), enable (
) }
2
29
Advertisement
Table of Contents
