Table of Contents
Advertisement
lsSdlcOperTable (portSdlcGroup.4)
This table contains Read only variables that reflect the actual operating parameter
values. Unless a value was changed in the
operational, the values in the
. The variables in the
dlcAdminTable
lSSdlcOperLocalSub (lsSdlcOperTable.1.1)
lSSdlcOperRemoteSub (lsSdlcOperTable.1.2)
lSSdlcOperAutoCall (lsSdlcOperTable.1.3)
lSSdlcOperRetryTime (lsSdlcOperTable.1.4)
lSSdlcOperRetryCount (lsSdlcOperTable.1.5)
lSSdlcOperLlc2Conversion (lsSdlcOperTable.1.6)
lSSdlcOperLPDAResourceID
lSSdlcAdminL2DatMode (lsSdlcOperTable.1.8)
lsSdlcLlc2AdminTable (portSdlcGroup.5)
This table contains information about the PUs configured on an SDLC port. Note that
deleting of a PU entry does not affect the existence of the PU for the running protocol.
The PU record is removed from the database file, but will remain known to the node
until it is rebooted or until an online update of the port is performed. This is consistent
with the way PU information is handled when configuring through the user interface
menu system.
lSSdlcLlc2AdminLocalSap
SYNTAX:
ACCESS:
STATUS:
DESCRIPTION:Local SAP address.
::= { lsSdlcLlc2AdminTable.1.1}
lSSdlcLlc2AdminLocalMac
SYNTAX:
ACCESS:
STATUS:
DESCRIPTION:Local MAC address.
::= { lsSdlcLlc2AdminTable.1.2}
lSSdlcLlc2AdminIdblk
SYNTAX:
ACCESS:
STATUS:
54
lsSdlcAdminTable
should match those configured in the
lsSdlcOperTable
lsSdlcOperTable
(lsSdlcOperTable.1.7)
INTEGER (
) (in multiples of 4)
0–252
Read/Write
Mandatory
PhysAddress
Read/Write
Mandatory
INTEGER (
)
0–4095
Read/Write
Mandatory
after the interface became
are listed below.
Cabletron Relay Access Products
lsS-
Advertisement
Table of Contents
