Table of Contents
Advertisement
::= { bsciSubscrAdminTable.1.8 }
bsciSubscrOperTable (portBsciGroup.4)
This table contains Read only variables that reflect the actual operating parameter
values. Unless a value was changed in the
became operational, the values in the
figured in the
bsciSubscrAdminTable
listed below.
bsciSubscrOperSequence (bsciSubscrOperTable.1.1)
bsciSubscrOperLocalID (bsciSubscrOperTable.1.2)
bsciSubscrOperRemoteID
bsciSubscrOperAutocall (bsciSubscrOperTable.1.4)
bsciSubscrOperAutocallRtyTimer (bsciSubscrOperTable.1.5)
bsciSubscrOperAutocallMaxRtry (bsciSubscrOperTable.1.6)
bsciSubscrOperConnectionID (bsciSubscrOperTable.1.7)
bsciDevAdminTable (portBsciGroup.5)
bsciDevAdminControlUnitID
SYNTAX:
ACCESS:
STATUS:
DESCRIPTION:Control Unit identifier.
::= { bsciDevAdminTable.1.1}
bsciDevAdminDeviceUnitID
SYNTAX:
ACCESS:
STATUS:
DESCRIPTION:Device Unit identifier.
::= { bsciDevAdminTable.1.2}
bsciDevAdminConnectionID
SYNTAX:
ACCESS:
STATUS:
DESCRIPTION:BSCI port connection ID for the device. This is an internal
MIB Reference
will be returned in response to a management protocol
retrieval operation. For a management protocol set opera-
tion, if other variable bindings are included in the same
PDU, then a
response is returned.
genErr
bsciSubscrAdminTable
bsciSubscrOperTable
. The variables in the
(bsciSubscrOperTable.1.3)
INTEGER (
)
0–31
Read only
Mandatory
INTEGER (
)
0–31
Read only
Mandatory
INTEGER (
)
0–255
Read/Write
Mandatory
after the interface
should match those con-
are
bsciSubscrOperTable
43
Advertisement
Table of Contents
