Portlogicalx25Opertable (Portx25Group.4); Portx25Admintable (Portx25Group.5) - Cabletron Systems SmartSwitch 1800 Reference Manual

::= { portLogicalX25AdminTable.1.5 }

portLogicalX25OperTable (portX25Group.4)

This table contains read-only variables that reflect the actual operating parameter
values. Unless a value was changed in the
became operational, the values in the
configured in the
portLogicalX25AdminTable
portLogicalX25OperTable
portLogicalX25OperFrDlci (portLogicalX25OperTable.1.1)
portLogicalX25OperCxnPriority (portLogicalX25OperTable.1.2)
portLogicalX25OperRfc1490 (portLogicalX25OperTable.1.3)
portLogicalX25OperBAG (portLogicalX25OperTable.1.4)

portX25AdminTable (portX25Group.5)

This is an Admin Table for both logical and physical ports. This table contains Netlink
Enterprise-specific objects to manage an X25 port. Changing one of these parameters
may take effect in the operating port immediately or may wait until the interface is
restarted depending on the details of the implementation. Most of the objects in this
read/write table have corresponding read-only objects in the port
return the current operating value. The operating values may be different from these
MIB Reference
use by the managed device, and which is supplied
by a management station wishing to exercise an
on-line update of the existing conceptual row. For a
management protocol set operation, a
response is returned when the row does not exist.
, which is supplied by a management
createAndGo
station wishing to create a new instance of a con-
ceptual row and to have its status automatically set
to active, making it available for use by the
managed device. For a management protocol set
operation, a
genErr
row already exists.
, which is supplied by a management station
destroy
wishing to delete all of the instances associated with
an existing conceptual row.
Note that all of the above values may be specified in a man-
agement protocol set operation, and only the
will be returned in response to a management protocol
retrieval operation. For a management protocol set opera-
tion, if other variable bindings are included in the same
PDU, then a
genErr
portLogicalX25AdminTable
portLogicalX25OperTable
. The variables in the
are listed below.
response is returned when the
response is returned.
after the interface
should match those
X25OperTable
genErr
value
active
that
15