Table of Contents
Advertisement
::= { portSdlcAdminTable.1.13 }
portSdlcAdminIdleFillChar
SYNTAX:
ACCESS:
STATUS:
DESCRIPTION:Specifies a character that will be inserted into the stream
::= { portSdlcAdminTable.1.14}
portSdlcAdminInactivityTimer
SYNTAX:
ACCESS:
STATUS:
DESCRIPTION:Determines how long the node will wait with no activity on
::= { portSdlcAdminTable.1.15}
portSdlcAdminL1Duplex
SYNTAX:
ACCESS:
STATUS:
DESCRIPTION:Determines whether level-1 (physical layer) transmission
::= { portSdlcAdminTable.1.16}
portSdlcOperTable (portSdlcGroup.2)
This table contains Read only variables that reflect the actual operating parameter
values. Unless a value was changed in the
became operational, the values in the
in the
portSdlcAdminTable
portSdlcOperMAXRetries (portSdlcOperTable.1.2)
portSdlcOperMAXOut (portSdlcOperTable.1.3)
portSdlcOperPadType (portSdlcOperTable.1.4)
portSdlcOperGenerateClock (portSdlcOperTable.1.5)
portSdlcOperRcvClockFromDTE (portSdlcOperTable.1.6)
portSdlcOperNrz
portSdlcOperPacketSize (portSdlcOperTable.1.8)
50
PDU, then a
response is returned.
genErr
INTEGER {hex-ff (
1
Read/Write
Mandatory
when theSNA link is idle.
INTEGER (
) (seconds)
15–250
Read/Write
Mandatory
the port before it will declare the attached device down.
INTEGER {full duplex (
Read/Write
Mandatory
can be in one (half duplex) or both (full duplex) directions
at once.
portSdlcAdminTable
portSdlcOperTable
. The variables in the
portSdlcOperTable
(portSdlcOperTable.1.7)
), hex-7e (
)}
2
), half duplex (
)}
1
2
after the interface
should match those configured
are listed below.
Cabletron Relay Access Products
Advertisement
Table of Contents
