Watering (Non-Maintenance Free) - Taylor-Dunn BG-015-00 Operation, T Roubleshooting And Replacement Parts Manual

WATERING (NON-MAINTENANCE FREE)

6. Clean the battery. Refer to Cleaning section for
information on cleaning the battery.
7. Check the electrolyte level in all battery cells. If low, fill
to the correct level with distilled water using part
number 77-201-00 battery filler, never add additional
battery electrolyte to a battery.
8. Reconnect the battery, remove the blocks from the
wheels and test drive.
Maintenance, Service, and Repair
Explosive mixtures of Hydrogen gas are present within battery cells
at all times. Do not work with or charge battery in an area where
open flames (including gas furnace or water heater pilots), sparks,
cigarettes, or any other sources of combustion are present. Always
provide ample ventilation in rooms where batteries are being charged.
Failure to do so may result in severe bodily injury and/or property
damage.
Battery electrolyte is poisonous and dangerous. It contains sulfuric
acid. Avoid contact with skin eyes or clothing. Wear rubber gloves
and safety glasses while servicing batteries. DO NOT INGEST! This
may result in severe bodily injury.
A battery is a live electrical source. It cannot be disconnected or
neutralized. Do not drop any tool or conductive object onto the battery.
A conductive object that comes in contact with the battery terminals
will initiate a short circuit of the battery. This could cause the battery
to explode resulting in severe bodily injury and/or property damage.
Do not overfill the batteries. Over filling the batteries may cause the
batteries to boil over and result in severe bodily injury or property
damage.
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Batteries Page 5