Taylor-Dunn BG-015-00 Operation, T Roubleshooting And Replacement Parts Manual page 87

10. Remove the retracting spring and torsion springs from the brake shoes.
Retracting spring
11. Remove the hair pin clips from the actuating arms
and discard.
Exploded brake adjuster assembly
12. Remove the brake shoes and brake adjustor
assembly from the backing plate.
13. Thoroughly clean and inspect the adjustor assembly.
Replace parts as required.
14. Apply a very light coating of high temperature grease
to the adjustor screw threads.
15. Install in reverse order.
16. Repeat for the opposite side.
17. Adjust the brakes. See
Brakes
section for information regarding adjusting
the brakes.
18. Set the park brake.
19. Reconnect the main positive and negative at the
batteries.
20. Lower the wheels to the ground.
21. Remove the blocks from behind the wheels.
22. Release the park brake and test drive the vehicle.
Maintenance, Service, and Repair
Adjust the Service
Brakes Page 17
Torsion springs
Brake Adjuster