Table of Contents
Advertisement
EXPERT LA
4.3
Controller Programs
Program definition
Programs are an assembly of settings (tempera-
ture settings, relay assignment, probe assignment,
etc.) that can be enabled at different moment of
the breeding process. In all, the controller can use
3 different programs.
Automatic program selection
The controller can automatically switch the pro-
gram selection when the animals reach a certain
age and/or as a function of outside temperature.
Refer to the Installation Setup section of this
manual to enable or disable the automatic program
switch (see section 4.5).
4.3.1
Program Selection & Settings
The controller can automatically switch the pro-
gram selection when the animals reach a certain
age and/or as a function of outside temperature. If
the automatic program switch option is enabled in
the Installation setup (sec. 4.5), you must indicate
the moment at which each program starts.
Select:
Main menu
Setup*
Program
*
A password may be required to access this menu (sec. 4.2).
Program #x above:
If the program switch is based on the ani-
mal age, select the day at which programs
2 and 3 start; if the switch is based on the
outside temperature, select the outside tem-
perature above which each program starts.
16
EXPERT LA rev.00
Refer to the Installation Setup section of this
manual to set the number of programs in use
and to enable or disable the automatic
program switch (section 4.5).
Program selection
When a program is selected, all parameter settings
displayed on screen are related to this program.
Make sure the right program is selected
before adjusting any parameter.
Program 2 above day:
Program 3 above day:
Program 2 above Out T:
Program 3 above Out T:
Show Settings :
[ or ]
Running Program: Program 1
Note that program 1 is automatically used
when the animal age (or outside tempera-
ture) is lower than the value defined for pro-
grams 2 and 3.
Main menu
Setup
Prog.Select
Program Settings
10
20
50.0
75.0
Program 1
Use
to navigate
Advertisement
Table of Contents
