Table of Contents
Advertisement
EXPERT LA
9.
CLOCK OUTPUTS
The controller has 2 outputs to control various de-
vices using the real-time clock. These clock output
can use up to 12 timer cycles.
A clock output starts when the On Time of a timer
is reached; it either stops after a certain run time
or at a certain time of day. The following diagrams
show both possibilities:
Output
Operating Mode: Start / Stop
Status
Cycle
On
Off
Start Time
Stop Time
(ex. 8H30 AM)
(ex. 9:00AM)
Operating Mode: Start / Run
Output
Status
Cycle
On
Off
Run Time
(ex.30min,15sec.)
Start Time
(ex. 8H30 AM)
66
EXPERT LA rev.00
Settings
Select:
Main menu
Start/Stop*
Clocks**
Clock #x
*
A password may be required to access this menu.
**
Accessible if at least 1 clock output is enabled in the Instal-
lation Setup (section 4.5).
Time
•
Set the following parameters:
Clock mode: the clock mode allows stopping
Time
a clock output at a certain time of day or
after a certain run time. Select "Start/Stop"
to specify the time at which each cycle
starts and stops or select "Start/Run" to
specify the running time of each cycle. Note
that the "Start/Run" option allows stopping
cycles with more precision since this mode
allows adjusting the seconds.
On Time / Off Time or Run Time
Set the time at which each cycle starts and
the moment at which each cycle ends.
Start/Stop
Clocks
Clock #x
Clock #X
Clock Mode
Start/Stop
1.
On
Time
6:00A h:m
Off Time
6:00A h:m
or
Clock Mode
Start/Run
1.
On
Time
6:00A h:m
Run Time Hour
0
Minutes
0
Seconds
0
Use
to navigate
Main menu
Advertisement
Table of Contents
