Temperature & Pressure Settings; Temperature Set Point - Airstream Cumberland EXPERT LA User Manual

Temperature controller
Table of Contents

Advertisement

EXPERT LA
5
TEMPERATURE &
PRESSURE SETTINGS
5.1

Temperature Set Point

The temperature set point is a target temperature
in the room. The activation of most outputs of the
controller is based on this reference temperature.
Select:
Main menu
Set Points
Temp.
The following parameters are displayed:
Temperature set points are common
to all programs of the controller.
Set Points
Current
Day
Night
Clean Mode
Outside
Curve Offset
Use
32
EXPERT LA rev.00
Main menu
Set Points
Temp.
Set Points
75.5 °F
70.0 °F
75.5 °F
35.0 °F
75.0 °F
0.0 °F
to navigate
Current set point
This is the current temperature set point in
use. This value cannot be changed; to modify
the set point, change the day or night set
points below.
Day set point
Set the temperature set point that is used
during the day (this set point is used all day
long if the night set point is not enabled).
The controller can also change the day set
point automatically over time by using a
curve (see section 5.3).
This parameter can only be modified while the set
point curve is inactive (sec. 5.3).
Night set point
A different temperature set point can be
used at night. The night set point can be used
to lower the target room temperature for
instance. The night set point is relative to
the day set point, which means that it is
automatically adjusted when the day set
point changes. Set the night set point to the
desired value.
Accessible if the night set point is enabled (see
section 4.9)
Clean mode set point
Select what is the target room temperature
while the controller operates in clean mode.
Outside set point
The controller can adjust the moving speed
of natural ventilation curtains as a function
of outside temperature. When this function
is used, the controller refers to the outside
temperature set point to control the moving
speed. Set the outside temperature to the
desired value.
Accessible if the outside temperature sensor is en-
abled in section 4.7.1 and if the curtain compen-
sation is enabled in the Installation Setup (sec. 4.5).

Advertisement

Table of Contents
loading

Table of Contents