Table of Contents
Advertisement
4.2
WAN INTERFACE CONFIGURATION SCREEN
This section describes the features of the WAN Interface Configuration
screen. Access the screen by using the arrow keys to highlight the WAN
INT CONFIG command field at the bottom of the WAN Physical
Configuration screen, then press ENTER. The WAN Interface
Configuration screen shown in
<host name> Local Management
Interface Number:
Max Xmit Unit:
ProtMgrIface:
Active Protocol:
FR LMI:
DLCI Address:
DLCI DCP En:
DLCI DCP Stat:
Comp Ratio:
Circuit State:
PORTS:
SAVE
[1-32]
Figure 4-2 WAN Interface Configuration Screen
4.2.1
WAN Interface Configuration Screen Fields
The following sections describe WAN Interface Configuration screen
fields.
Interface Number (Modifiable)
Displays the active Interface Number. Use this field to configure the
Interface Number assigned to the timeslots on the WAN Physical
Configuration screen.
Max Xmit Unit (Modifiable)
User configured field that displays the maximum packet size that can be
transmitted on the selected interface. The default settings for this field
(1526 for PPP and 4095 for Frame Relay) depend on the Protocol
Manager selected.
WPIM-T1/DDS User's Guide
Figure 4-2
WAN INTERFACE CONFIGURATION
CKT# IF# LID STATE
000
001
0
002
[0]
003
FR
004
[ANSI_94]
005
0
006
007
008
009
010
[Invalid]
011
012
013
014
015
RETURN
016
WAN Interface Configuration Screen
displays.
CKT# IF# LID STATE
017
001 Enet
UP
018
002 Enet DOWN
019
020
021
022
023
024
025
026
027
028
029
030
031
032
Flash Image Version: xx.xx.xx
2750_02
4-5
Advertisement
Table of Contents
