Table of Contents
Advertisement
Chapter 3: Local Management for T1 Service
The line configuration information shown in
by the service provider.
Configuration Information
Required by Customer
Line Coding
Frame Type
Clock Source
DS-0s (Timeslots)
3.5.1
Frame Relay Physical Configuration
Begin the WPIM-T1/DDS physical configuration by accessing the WAN
Physical Configuration screen through Local Management
Proceed with the following steps:
1.
Use the arrow keys to highlight the WPIM X field at the bottom of the
screen. Press the SPACE bar to select the number of the WPIM to be
configured, then press ENTER.
Use the arrow keys to highlight the MgrType field. Configure Protocol
Manager Type as either FR PtoMP or FR PtoP. There are two settings for
Frame Relay, Point to Point (FR PtoP) and Point to Multipoint (PtoMP).
Frame Relay Point to Point has one Interface per DLCI assigned when
DLCIs are created by the Service Provider. In Frame Relay Point to
Multipoint, there is one interface to multiple DLCIs, and the DLCIs are
dynamically learned. Backup can only be run on FR PtoP, not FR PtoMP.
When changing from one protocol to another on a
NOTE
WPIM-T1/DDS that has been operational, save NONE as the
protocol before changing to another protocol.
2.
Use the arrow keys to highlight Timeslot View. Press the SPACE bar
to select New, then press ENTER. The cursor moves to the first
timeslot available in the Timeslot Configuration Table.
3-18
Table 3-3 Telco Configuration Information
Table 3-3
Information Supplied by Service
Provider
B8ZS or AMI
ESF or D4
Loop Timing or Local Timing
Timeslots being used for each end of
the circuit
WPIM-T1/DDS User's Guide
must be supplied
(Figure
3-1).
Advertisement
Table of Contents
