Cabletron Systems WPIM T1 User Manual page 35

3.3 FULL T1 CONFIGURATION USING PPP
This section provides step-by-step instructions for configuring the
WPIM-T1/DDS to use a full T1 circuit in a PPP environment. This
simplified example assumes the setup shown in
CSX400 with a WPIM-T1/DDS installed at Site #1. Configurations may
vary depending on the host platform.
SITE #1
24 Timeslots
The line configuration information shown in
by the service provider.
Configuration Information
Required by User
Line Coding
Frame Type
Clock Source
WPIM-T1/DDS User's Guide
Figure 3-6 Full T1 Configuration
Table 3-1 Telco Configuration Information
Full T1 Configuration Using PPP
Telco Cloud
Table 3-1
Configuration Information
Supplied by Service Provider
B8ZS or AMI
ESF or D4
Loop Timing or Local Timing
Figure 3-6 using a
SITE #2
24 Timeslots
1482_05
must be supplied
3-11