Table of Contents
Advertisement
Chapter 4: Local Management for DDS Service
4.1
THE WAN PHYSICAL CONFIGURATION SCREEN
To access the WAN Physical Configuration screen in Local Management,
use the arrow keys to highlight the WAN SETUP menu item, then press
ENTER. The screen shown in
WPIM-T1/DDS in DDS mode.
<host name> Local Management
WPIM 1
Type:
DDS
WPIM #:
1
MgrType: [None]
Max VCs: 000
Next IF:
N/A
WPIM 1 Line Configuration
DDS Line Mode:
DDS Tx Clock Source:
DDS Loop-Back:
SAVE
Figure 4-1 WAN Physical Configuration Screen
4.1.1
WAN Physical Configuration Screen Fields
The following sections describe WAN Physical Configuration screen
fields and provide instructions for setting them. The WAN Physical
Configuration screen lets you configure the WPIM or "Physical
Interface."
When there is more than one WPIM installed into the host
NOTE
platform, information for the second WPIM will display next to
WPIM 1.
The Type field displays either T1 or DDS, depending on the
mode selected using Network Tools.
4-2
Figure 4-1
WAN PHYSICAL CONFIGURATION
[DDS-PRI]
[Loop-Timing]
[NONE]
[WPIM 1]
WAN INT CONFIG
displays, with the
Flash Image Version: xx.xx.xx
DDS In-Speed:
DDS Out-Speed:
REMOTE SETUP
RETURN
WPIM-T1/DDS User's Guide
56000
56000
2750_01
Advertisement
Table of Contents
