Table of Contents
Advertisement
4.3
DDS SERVICE CONFIGURATION
This section provides step-by-step instructions for connecting the
WPIM-T1/DDS to a Digital Data Service circuit in a PPP or Frame Relay
environment. This example assumes the setup shown in
two CSX400s with WPIM-T1/DDS modules installed.
Host Platform
WPIM-T1/ DDS
in DDS mode
Site #1
Figure 4-4 WPIM-DDS Interface Configuration for PPP
The line configuration information shown in
by the service provider.
Configuration Information
Required By User
Clock Source
Line Mode
FR-LMP (Frame Relay Only)
4.3.1
DDS Service Physical Configuration
Begin the DDS configuration by accessing the WAN Physical
Configuration screen
the WAN Physical Configuration screen, use the arrow keys to highlight
the WAN Setup option, then press ENTER. The screen shown in
Figure 4-1
displays. Proceed with the following steps:
1.
Use the arrow keys to highlight the WPIM X field at the bottom of the
screen. Press the SPACE bar to select the number of the WPIM being
configured, then press ENTER.
WPIM-T1/DDS User's Guide
Table 4-1 Telco Configuration Information
(Figure
4-1) through Local Management. To access
DDS Service Configuration
Telco Cloud
Table
Configuration Information
Supplied By Service Provider
Telco provided or no clock source
Primary or Clear Channel
Telco provided or user requested
Figure 4-4
Host Platform
WPIM-T1/ DDS
in DDS mode
Site #2
4-1, must be supplied
using
2750_03
4-9
Advertisement
Table of Contents
