Table of Contents
Advertisement
This chapter describes the features of the WPIM-T1/DDS. It also briefly
explains the WAN protocols supported by the WPIM-T1/DDS.
Some steps for successful operation of this device are:
•
Install the WPIM-T1/DDS in a Wide Area Network host platform.
Refer to
Chapter 2
appropriate host manual (i.e., the Cabletron Systems CyberSWITCH
CSX400 and CSX400-DC Installation Guide for other installation and
troubleshooting procedures.
•
Access Local Management. Refer to the appropriate host platform
Local Management User's Guide for instructions on setting up and
accessing Local Management.
•
Select the service desired, T1 or DDS, using Network Tools.
•
Once the desired service has been chosen, refer to the appropriate
chapter in this document for setup information.
Due to the automation of setup features, it is strongly recommended to
use the Graphical User Interface, QuickSET, to fully configure the device.
QuickSET is the desired method for configuring the WPIM-T1/DDS,
after using Local Management to choose T1 or DDS service. Check the
Release Notes for the availability of QuickSET for configuration. Use
Local Management, described in this manual, if QuickSET is not
available.
The device in which the WPIM-T1/DDS is to be installed may
NOTE
be referred to as the host platform in this documentation.
WPIM-T1/DDS User's Guide
CHAPTER 1
OVERVIEW
for direction on installation procedures. Refer to the
1-1
Advertisement
Table of Contents
