Table of Contents
Advertisement
2.1.4
Post-Installation
1.
Reinstall the cover as applicable.
2.
Refer to the host platform user's guide to reinstall the network cables
and refer to
WPIM-T1/DDS. Do not connect the WAN cable until instructed to
do so.
3.
Refer to instructions contained in the host platform user's guide to
reapply power.
4.
After reapplying power, check the LEDs for the following conditions:
•
Verify that the PWR LED is on, indicating that the device is
receiving power.
•
After the host platform runs a self test, the CPU LED blinks green
indicating normal operation.
•
If the CPU LED remains red, contact Cabletron Systems.
WPIM-T1/DDS User's Guide
WPIM
Figure 2-1 Installing the WPIM-T1/DDS
Appendix A
for cabling information for the
Installing the WPIM-T1/DDS
WPIM Screws
T 1
D D
S
W P
W P
I M
T 1
I M
/ D D
- R
T 1
S
Standoffs
WPIM
Connector
WPIM
Connector Pins
2-3
Advertisement
Table of Contents
