Table of Contents
Advertisement
Chapter 3: Local Management for T1 Service
CCP Enable (Toggle)
Toggles between On and Off to enable or disable compression.
CCP Status (Read-Only)
Displays the status of compression.
Comp Ratio (Read-Only)
Displays the Compression Ratio, which is the ratio of uncompressed to
compressed data.
3.2.1.3
Command and Interface Table Fields
SAVE (Command)
Saves the configuration changes.
PORTS: [1-32] (Command)
Interface table displays the range of circuits shown in the command field.
Use the SPACE bar and either the BACKSPACE or DELETE key to step
through the displays.
RETURN (Command)
Returns user to the previous screen.
CKT# (Read-Only)
Displays the circuit number of the application ports available from the
host platform. If the active protocol is PPP or FR PtoP, only one
application port per interface number (IF#) is assigned. If the active
protocol is FR PtoMP, the available WAN ports from the host platform
may be assigned, one per DLCI.
IF# (Read-Only)
Displays the MIB II Interface number that is associated with the
application port (CKT#).
LID (Read-Only)
Displays the Link Identifier. If the active protocol is Frame Relay, the
Data Link Connection Identifier is displayed. If the active protocol for
this interface is PPP, then PPP displays in this field. For Ethernet ports,
Enet is displayed.
STATE (Read-Only)
Displays the status of the application port. If the active protocol is Frame
Relay, this field displays the status as Active, Inactive, or Invalid
(no LMI). If the active protocol is PPP or Ethernet, this field displays UP
(active) or DOWN (inactive).
3-10
WPIM-T1/DDS User's Guide
Advertisement
Table of Contents
