Table of Contents
Advertisement
Pulse Cleaning
The manual air pulse jet button is used for filter cleaning during operation and between removal
cleaning and replacement.
For maximum effectiveness should be used as follows:
1. Power the down draft table off.
2. Press and release the air pulse button one to two
times.
3. This type of cleaning should be daily or as any
decrease in vacuum is observed.
4. If the operating vacuum is weak after manual pulse
cleaning and the measurement of pressure still
exceeds 6" WIC on the pressure gauge, remove
the metal filter, clean and re-install.
5. If vacuum remains weak after cleaning the filter, it
will be necessary to replace the filter(s).
Work Lamp Light Switch and Outlet Box
Located on the left side of the table is the light switch
and outlet box.
• Connect the separate power lead from the light
switch and outlet box to a 110V power supply.
• Lifting the paddle switch supplies power to the
work lamp and to the two 110V outlets in the box.
• Pressing the paddle inward removes power from
the work lamp and the outlets. This removes power
from any tool which may be plugged into these
outlets.
24
24
Advertisement
Table of Contents
