System Alarm; Motion Alarm - Nuvico np p402 User Manual

49 | FULL HD Network Video Recorder

4.4.2 System Alarm

S.M.A.R.T. alarm is an alarm signal triggered when the HDD is about to be out of operation.
Connection Failure alarm is activated when a camera is disconnected.
Recording failure alarm is triggered when the NVR doesn't record normally.
Fan Failure alarm is triggered when the internal fan is stopped.
Users can also set the percentage for HDD Usage. For example, when usage is 50%, the NVR will notify by a camera popup
or a beep sound when HDD is 50%.

4.4.3 Motion Alarm

Select Motion alarm to record only when motion detection is triggered by the NVR S/W upon the users defined motion area.
An alarm signal is sent via the selected sensor-out channel.

COPY SETTINGS
Upon pressing the Copy Settings button, the Copy Settings popup will appear. In this popup, choose the camera
the user wants to copy in the "From" field. Choose the parameters such as Use, Notify, Relay, and Dwell Time
on the check box. Check on the checkbox next to the sensor numbers to apply the copy setting(s) to another
channel on the "To" box.
N "Motion Alarm" here means alarm triggered by motion detection set by motion menu of Network Camera.
OTE
4.4.4 Notification

Remote Notify
The system can notify an alarm message to the IP address of the Advanced Client Software over the network.
Users can choose from a selection of different kinds of alarms by pressing "ADD." Alarms can be generated by Sensor,
Motion Detection, Disk Full, Admin PW Changed, Video Loss, and Power On/Off.