Configuring Server And Http Ports; Configuring Https Port - Nuvico HDoCS DT_E/P Instruction Manual

Table of Contents

9.2.8 Configuring Server and HTTP Ports

You can change the server and HTTP ports in the Network Settings menu. The default server port is 8000 and

the default HTTP port is 80.

Steps:

1. Enter the Network Settings interface.

Menu > Configuration > Network

2. Select the More Settings tab to enter the More Settings interface, as shown in Figure 9. 24.

3. Enter new Server Port and HTTP Port.

4. Enter the Server Port and HTTP Port in the text fields. The default Server Port is 8000 and the HTTP Port

is 80, and you can change them according to different requirements.

5. Click the Apply button to save and exit the interface.

NOTE

The Server Port should be set to the range of 2000-65535 and it is used for remote client software access. The

HTTP port is used for remote web browser access.

HTTPS provides authentication of the web site and associated web server that one is communicating with,

which protects against Man-in-the-middle attacks. Perform the following steps to set the port number of https.

Example:

If you set the port number as 443 and the IP address is 192.0.0.64, you may access the device by inputting

https://192.0.0.64:443 via the web browser.

NOTE

The HTTPS port can be only configured through the web browser.

Figure 9. 24 Host/Others Settings Menu

Table of Contents