Table of Contents
Advertisement
7.13 Accelerator Module Power Connector Board Replacement (iPC –
D50TNP2MFALAC Only)
The following provides instructions for the replacement of the power connector board on the Intel® D50TNP
Accelerator Module (D50TNP2MFALAC).
Required Tools and Supplies:
•
Anti-static wrist strap and conductive foam pad (recommended)
•
Phillips* head screwdriver #2
1. Remove the accelerator riser assembly from the Accelerator Module. Follow steps 1 through 11 of
Section 7.11.
Figure 256. Accelerator Module Power Connector Board Removal
2. Remove the black screw and the silver screws that secure the power connector board to the Accelerator
Module (see Letter A).
3. Carefully remove the power connector board by lifting it up and away from the module (see Letter B).
4. Locate and unpack the new power connector board for replacement.
Intel® Server D50TNP Family Integration and Service Guide
173
Advertisement
Table of Contents
