7.20 Power Distribution Board (Pdb) Assembly Replacement; Figure 280. Removing The Back Cover - Intel D50TNP Integration And Service Manual

7.20 Power Distribution Board (PDB) Assembly Replacement

Required Tools and Supplies:
• Anti-static wrist strap and conductive foam pad (recommended)
• Phillips* head screwdriver #1
1. Power the system down and remove it from the rack.
Important Safety Note: Due to the weight of a fully configured system, Intel recommends:
- use a mechanical lift to aid with the removal of the system from the rack, and/or
- use at least two people to remove the system from the rack, or
- remove all installed modules from the system before attempting to remove the system from the rack.
2. Make sure all modules are removed from the server chassis (see
3. Locate the chassis back cover and remove the four screws with a Phillips head screwdriver (see Letter A).
4. Slide the cover towards the back and lift it up (see Letter B).
188
Intel® Server D50TNP Family Integration and Service Guide

Figure 280. Removing the Back Cover

Section 7.1.1).