USB Deviceserver User Manual Linux
7.2
How to Reset Parameters to their Default Values
You can reset the UTN to its default values, e.g. if you want to install the UTN server in a different network. All set-
tings will be set to factory settings. Installed certificates will not be deleted.
Important:
The connection to the utnserver Control Center may be interrupted if the IP
address of the UTN server changes with the reset.
If required, determine the new IP address 20.
You can change the settings either via remote access (utnserver Control Center and SEH Product Manager) or us-
ing the Reset button on the UTN server.
If you lost the password for the utnserver Control Center, you can reset the UTN server
using the reset button. You do not need a password to do so.
• Resetting Parameters from the utnserver Control Center 78
• Resetting Parameters via Reset Button 78
Resetting Parameters from the utnserver Control Center
1. Start the utnserver Control Center.
2. Select MAINTENANCE – Default settings.
3. Click Reset device.
A security query appears.
4. Confirm the security query.
The parameters are reset.
Resetting Parameters via Reset Button
With the reset button you can reset the UTN server's parameter values to their default settings.
1. Press the reset button for 5 seconds.
The UTN server restarts.
The parameters are reset.
78
Need help?
Do you have a question about the myUTN utnserver Pro and is the answer not in the manual?