SEH myUTN utnserver Pro User Manual page 67

USB Deviceserver User Manual Linux
Entering a USB Port Key (Unlocking a USB Device)
When USB port key control is enabled in the SEH UTN Manager, neither the USB port nor the connected USB de-
vice are shown, which means the connection cannot be established.
To gain access to the protected USB device, the key must be entered on the client in the SEH UTN Manager. Since
the port key applies only to the user account currently in use on the client, you must enter it into each client user
account that should have access to the USB device (user port key). The USB port and the connected USB device
will then appear and can be used.
1. Start the SEH UTN Manager.
2. In the selection list, select the UTN server.
3. In the menu bar, select UTN Server – Set User Port Keys.
The Enter User Port Key dialog appears.
4. Enter the key for the relevant USB port.
5. Click OK.
 Access is granted.
Important:
If you are using Auto-Connect ( 44) in combination with USB port keys, you
must enter the key separately as the Auto-Connect port key. These apply system-
wide.
In the menu bar, select UTN Server – Enter Auto-Connect Port Key.
Configuring USB Port Device Mapping
1. Start the utnserver Control Center.
2. Select SECURITY – USB.
3. In the USB port table for the desired USB port, click the Change
The USB Port page appears.
4. Go to the Method list and click Device Assignment.
5. Click Assign device.
The USB device box shows the VID and PID of the USB device.
6. To confirm, click Save.
 The settings will be saved. Only the assigned USB device model can be operated on the USB port.
To deactivate the feature, go to the Method list and select ---.
To assign a different USB device to the USB port, connect the USB device to the USB
port and repeat the USB port device mapping.
Configuring USB Port Keys in Combination with USB Port Device Mapping
Combine the USB port key control and USB port device mapping security methods to use only the USB devices of
the assigned USB device model on the USB port and further restrict access to them (over time periods).
1. Start the utnserver Control Center.
2. Select SECURITY – USB.
3. In the USB port table for the desired USB port, click the Change
The USB Port page appears.
4. Go to the Method list and click Port key control/Device mapping.
5. For Key 1, click the Generate button, or enter a freely definable key in the box (max. 64 ASCII characters).
6. Optional: For Key 2, repeat step 5.
icon.
icon.
63