SEH myUTN utnserver Pro User Manual page 101

USB Deviceserver User Manual Linux
Parameters
trapusb
[Send USB port and
USB device informa-
tion]
trap_sdcard
[Send SD card informa-
tion]
Table 8.3-12: Parameter list – SSL/TLS
Parameters
sslmethod
[Encryption protocol]
security
[Encryption level]
Value Default
on/off off
on/off off
Value Default
any any
tls10
tls11
tls12
1-4 4
[1 character; 1–4]
Description
Enables/disables sending SNMP traps with
information about the USB port and connected
USB devices (enable or disable a USB port, con-
nect or remove a USB device, etc.)
Enables/disables sending SNMP traps with SD
card information (connect or remove an SD
card, unusable SD card, etc.).
Description
Defines the encryption protocol for SSL/TLS
connections.
any = at will (automatic negotiation)
tls10 = TLS 1.0
tls11 = TLS 1.1
tls12 = TLS 1.2
WARNING
Current browsers do not support
SSL. If you use SSL with a current
browser and the setting HTTPS
only for access to the utnserver
Control Center Control Center (
59), a connection cannot be
established.
Use TLS (and not SSL).
Defines the encryption level for SSL/TLS con-
nections.
1 = low
2 = medium
3 = high
4 = any (automatic negotiation)
WARNING
Current browsers do not support
cipher suites from the Low level. If
you use Low with a current
browser and the setting HTTPS
only for access to the utnserver
Control Center Control Center (
59), a connection cannot be
established.
Use an encryption level as high as
possible.
97