SEH myUTN utnserver Pro User Manual page 100

USB Deviceserver User Manual Linux
Parameters
notistat_h
[hh]
notistat_tm
[mm]
notisys_1
notisys_2
[Send system informa-
tion]
notiusb_1
notiusb_2
[Send USB port and
USB device informa-
tion]
notisdcard_1
notisdcard_2
[Send SD card informa-
tion]
trapto_1
trapto_2
[Address]
trapcommu_1
trapcommu_2
[Community]
trapversion_1
trapversion_2
[SNMP version]
trapsys
[Send system informa-
tion]
Value Default
0-23 0
[1–2 characters; 0–
9]
0-5 0
[1 character; 0–5]
on/off off
on/off off
on/off off
valid IP address 0.0.0.0
max. 64 characters public
[a–z, A–Z, 0–9]
---
v1
v3
on/off off
Description
Specifies the time (hour) at which a status email
is sent.
1 = 1. hour
2 = 2. hour
3 = 3. hour
etc.
Specifies the time (minute) at which a status
email is sent.
0 = 00 min
1 = 10 min
2 = 20 min
3 = 30 min
4 = 40 min
5 = 50 min
Enables/disables sending emails with system
information (reboot, network connections,
power supply, temperature warnings, etc.).
Enables/disables sending emails with informa-
tion about the USB port and connected USB
devices (enable or disable a USB port, connect
or remove a USB device, etc.)
Enables/disables sending emails with SD card
information (connect or remove an SD card,
unusable SD card, etc.).
SNMP trap address of the recipient.
SNMP trap community of the recipient.
Defines the SNMP protocol version for SNMP
trap sending.
--- = none
v1 = SNMPv1
v3 = SNMPv3
Enables/disables sending SNMP traps with sys-
tem information (reboot, network connections,
power supply, temperature warnings, etc.).
96