Table of Contents
Advertisement
Distributor of Digi International: Excellent Integrated System Limited
Datasheet of 101-1274 - KIT DEV STANDARD RCM5700
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
To develop and debug programs for the RCM5700/RCM6700 (and for all other Rabbit hardware),
you must install and use Dynamic C. This chapter provides a tour of its major features with
respect to the RCM5700/RCM6700.
3.1 Introduction
To help familiarize you with the RCM5700/RCM6700 modules, Dynamic C includes several
sample programs. Loading, executing and studying these programs will give you a solid hands-on
overview of the RCM5700/RCM6700's capabilities, as well as a quick start with Dynamic C as an
application development tool.
NOTE: The sample programs assume that you have at least an elementary grasp of ANSI C. If
you do not, see the introductory pages of the Dynamic C User's Manual for a suggested reading
list.
In order to run the sample programs discussed in this chapter and elsewhere in this manual,
1. Your RCM5700/RCM6700 must be installed on the Interface Board as described in Chapter 2,
"Getting Started."
2. Dynamic C must be installed and running on your PC.
3. The USB cable must connect the Interface Board to your PC.
4. Power must be applied to the RCM5700/RCM6700 through the Interface Board.
Refer to Chapter 2, "Getting Started," if you need further information on these steps.
To run a sample program, open it with the
it by selecting
in the Run menu (or press
Run
Mode (see Figure 4-12) and must be connected to a PC using the USB cable.
Complete information on Dynamic C is provided in the Dynamic C User's Manual.
MiniCore RCM5700/RCM6700 User's Manual
3. R
UNNING
menu (if it is not still open), then compile and run
File
). The RCM5700/RCM6700 must be in Program
F9
digi.com
S
P
AMPLE
ROGRAMS
19
Advertisement
Table of Contents
