Table of Contents
Advertisement
Distributor of Digi International: Excellent Integrated System Limited
Datasheet of 101-1274 - KIT DEV STANDARD RCM5700
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
This chapter describes the RCM5700/RCM6700 hardware in more detail, and explains how to set
up and use the accompanying Interface Board.
NOTE: This chapter (and this manual) assume that you have the RCM5700/RCM6700
Development Kit. If you purchased an
the information in this chapter and elsewhere to your test and development setup.
2.1 Install Dynamic C
Dynamic C must be installed to develop and debug programs for the RCM5700/RCM6700 series
of modules (and for all other Rabbit hardware). The latest version of Dynamic C is included on
CD in the Development Kit and is also available for download on our website at www.digi.com.
If you have not yet installed Dynamic C, do so now by inserting the Dynamic C CD from the
Development Kit in your PC's CD-ROM drive. If autorun is enabled, the CD installation will
begin automatically.
If autorun is disabled or the installation does not start, use the Windows
dows Disk Explorer to launch
The installation program will guide you through the installation process. Most steps of the process
are self-explanatory.
Once your installation is complete, you will have up to three new icons on your PC desktop. One
icon is for Dynamic C, another opens the documentation menu, and the third is for the Rabbit Field
Utility, a tool used to download precompiled software to a target system.
If you have purchased any of the optional Dynamic C modules, install them after installing
Dynamic C. The modules may be installed in any order. You must install the modules in the same
folder where Dynamic C was installed.
MiniCore RCM5700/RCM6700 User's Manual
2. G
MiniCore
from the root folder of the CD-ROM.
setup.exe
digi.com
S
ETTING
TARTED
module by itself, you will have to adapt
Start | Run
menu or Win-
11
Advertisement
Table of Contents
