Table of Contents
Advertisement
Distributor of Digi International: Excellent Integrated System Limited
Datasheet of 20-101-1194 - MODULE RABBITCORE RCM3309 ROHS
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
3. R
To develop and debug programs for the RCM3309/RCM3319
(and for all other Rabbit hardware), you must install and use
Dynamic C.
3.1 Introduction
To help familiarize you with the RCM3309 and RCM3319 modules, Dynamic C includes
several sample programs. Loading, executing and studying these programs will give you a
solid hands-on overview of the RCM3309/RCM3319's capabilities, as well as a quick
start using Dynamic C as an application development tool.
NOTE: The sample programs assume that you have at least an elementary grasp of the C
programming language. If you do not, see the introductory pages of the Dynamic C
User's Manual for a suggested reading list.
In order to run the sample programs discussed in this chapter and elsewhere in this manual,
1. Your RCM3309/RCM3319 must be plugged in to the Prototyping Board as described
in Chapter 2, "Getting Started."
2. Dynamic C must be installed and running on your PC.
3. The programming cable must connect the programming header on the RCM3309/
RCM3319 to your PC.
4. Power must be applied to the RCM3309/RCM3319 through the Prototyping Board.
Refer to Chapter 2, "Getting Started," if you need further information on these steps.
To run a sample program, open it with the
.
F9
Complete information on Dynamic C is provided in the Dynamic C User's Manual.
User's Manual
S
UNNING
AMPLE
menu, then compile and run it by pressing
File
P
ROGRAMS
15
Advertisement
Table of Contents
