Table of Contents
Advertisement
Distributor of Digi International: Excellent Integrated System Limited
Datasheet of 101-1274 - KIT DEV STANDARD RCM5700
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
F.4.2 How to Set Up your Computer for Direct Connect
Follow these instructions to set up your PC or notebook. Check with your administrator if you are
unable to change the settings as described here since you may need administrator privileges. The
instructions are specifically for Windows 2000, but the interface is similar for other versions of
Windows.
TIP: If you are using a PC that is already on a network, you will disconnect the PC from that net-
work to run these sample programs. Write down the existing settings before changing them to
facilitate restoring them when you are finished with the sample programs and reconnect your
PC to the network.
1. Go to the control panel (
work icon.
2. Select the network interface card used for the Ethernet interface you intend to use (e.g.,
Xircom Credit Card Network Adapter
which version of Windows your PC is running, you may have to select the "Local Area Con-
nection" first, and then click on the "Properties" button to bring up the Ethernet interface dia-
log. Then "Configure" your interface card for a "10Base-T Half-Duplex" or an "Auto-
Negotiation" connection on the "Advanced" tab.
NOTE: Your network interface card will likely have a different name.
3. Now select the
IP Address
on "Properties" to assign an IP address to your computer (this will disable "obtain an IP
address automatically"):
IP Address : 10.10.6.101
Netmask : 255.255.255.0
Default gateway : 10.10.6.1
4. Click
or
<OK>
<Close>
MiniCore RCM5700/RCM6700 User's Manual
Start > Settings > Control Panel
) and click on the "Properties" button. Depending on
tab, and check
Specify an IP Address
to exit the various dialog boxes.
digi.com
), and then double-click the Net-
, or select TCP/IP and click
TCP/IP
100
Advertisement
Table of Contents
