Chapter 3. Running Sample Programs; Introduction - Rabbit RCM3365 User Manual

3. R
To develop and debug programs for the RCM3365/RCM3375
(and for all other Rabbit hardware), you must install and use
Dynamic C.

3.1 Introduction

To help familiarize you with the RCM3365 and RCM3375 modules, Dynamic C includes
several sample programs. Loading, executing and studying these programs will give you a
solid hands-on overview of the RCM3365/RCM3375's capabilities, as well as a quick
start using Dynamic C as an application development tool.
NOTE: The sample programs assume that you have at least an elementary grasp of the C
programming language. If you do not, see the introductory pages of the Dynamic C
User's Manual for a suggested reading list.
More complete information on Dynamic C is provided in the Dynamic C User's Manual.
In order to run the sample programs discussed in this chapter and elsewhere in this manual,
1. Your RCM3365/RCM3375 module must be plugged in to the Prototyping Board as
described in Chapter 2, "Getting Started."
2. Dynamic C must be installed and running on your PC.
3. The RCM3365/RCM3375 module must be connected to your PC either through the
serial programming cable or through an Ethernet cable/network if you have a
RabbitSys-enabled RCM3365.
4. Power must be applied to the RCM3365/RCM3375 through the Prototyping Board.
Refer to Chapter 2, "Getting Started," if you need further information on these steps.
Since the RCM3365 and the RCM3375 run at 44.2 MHz and are equipped with a fast pro-
gram execution SRAM, remember to allow the compiler to run the application in the fast
program execution SRAM by selecting
Dynamic C
Options > Project Options > Compiler
To run a sample program, open it with the
pile and run the program.
User's Manual
S
UNNING AMPLE
Code and BIOS in Flash, Run in RAM
menu, then press function key
File
P
ROGRAMS
menu.
from the
to com-
F9
19