Chapter 3. Running Sample Programs; Introduction - Rabbit RCM3000 User Manual

3.1 Introduction

To help familiarize you with the RCM3000 modules, Dynamic C includes several sample
programs. Loading, executing and studying these programs will give you a solid hands-on
overview of the RCM3000's capabilities, as well as a quick start with Dynamic C as an
application development tool.
Complete information on Dynamic C is provided in the Dynamic C User's Manual.
In order to run the sample programs discussed in this chapter and elsewhere in this manual,
1. Your RCM3000 module must be plugged in to the Prototyping Board as described in
2. Dynamic C must be installed and running on your PC.
3. The RCM3000 module must be connected to your PC through the serial programming
4. Power must be applied to the RCM3000 through the Prototyping Board.
Refer to Chapter 2, "Hardware Setup," if you need further information on these steps.
To run a sample program, open it with the
pile and run the program.
User's Manual
Downloaded from Elcodis.com electronic components distributor
3. R
To develop and debug programs for the RCM3000 (and for all
other Rabbit Semiconductor hardware), you must install and use
Dynamic C.
NOTE: The sample programs assume that you have at least an elementary grasp of the C
programming language. If you do not, see the introductory pages of the Dynamic C
User's Manual for a suggested reading list.
Chapter 2, "Hardware Setup."
cable.
S
UNNING AMPLE
File menu, then press function key
P
ROGRAMS
F9 to com-
11