King gates STARG8 24NG Installation And Use Instructions Manual page 23

2. Product description
2.1 - Commissioning
To start-up the system, the following steps must be carried out:
1 - Check cabling, tighten all connections and terminals. Follow
cabling standards and regulations of the country/region.
2 - Set the dip switches (par. 4.1) and knobs (par. 4.2) according
to the desired typs pf operation and the system structural
configuration.
3 - Memorise the transmitters (Paragraph 5).
4 - Programme the gate travel path (Paragraph 6) so that the
control unit learns the gates open and close points.
5 - Perform the checks described in the "Testing and
commissioning" paragraph (Paragraph 7).
m
If, after completing these steps, the control
unit should malfunction, consult Paragraph 8, "LEDs
indication", to identify any issues, and Paragraph 10,
"F.A.Q", to attempt to solve it.
2.2 - Main features
- Automated access command for 1 or 2 24V motors.
Configuration of dip switch one and two specify the
type of motor in use
- Flasher control with/without integrated intermittency function
(Paragraph 10.3).
- Integrated management for electric locks 24V max. 15VA
(Paragraph 10.4). This output can also be used to control
courtesy lights (Paragraph 14).
- Double NC input for opening and closing limit switch
(Paragraph 10.8).
- Inputs for start, stop and pedestrian opening wired
commands, customisable to open, stop and close (Paragraph
10.9).
- Double input for photocells and safety edges: PHO1 during
closing and PHO2 during closing and/or opening (Paragraph
10.5).
- Possibility of powering 24VDC accessories (Paragraph 10.6).
- Input for gate status pilot light signalling the position of the
leaves (Paragraph 10.7).
- Input for external antenna that can be used for increasing the
range of the transmitters (Paragraph 10.10).
- Staggered closing of gate leaves adjustable through the knob
(Paragraph 4.2).
- Pause time for automatic re-closing adjustable to between 0
and 180 sec. with knob (Paragraph 4.2).
- Obstacle sensitivity adjustment with knob (Paragraph 4.2).
- Motor force adjustment with knob (Paragraph 4.2).
- Incorporated radio receiver (433.92MHz), compatible with
King Gates rolling transmitters.
- 6 indication LEDs (Paragraph 8).
- Slow-speed opening and closing (customisable through
dedicated programming).
2.3 - Technical features of the
control unit
Mains power supply
Motor power supply
Warning light power supply
Gate pilot lamp power supply
Accessories' power supply
(photocells...)
Radio receiver frequency
Storable remote controls
Radio antenna input
Operating temperature
230 Vac ±10%, 50 - 60 Hz
24V DC 280W e 10A
massimo picco per motore
24V max 15W
24Vdc max 10 W
24 Vdc max 10 W
433.920 MHz
170
RG58
-20 ÷ 50 °C
21