King gates STARG8 24NG Installation And Use Instructions Manual page 22

1. General Warnings
1.1 - Safety warnings
m
CAUTION!
This manual contains important instructions
and warnings for personal safety. Wrong installation
can cause serious injuries.
Before starting work read all the manual carefully.
If in doubt, stop installation and ask the King Gates Assistance
Department for clarifications.
m
According to the most recent European legislation,
the realisation of an automatic door or gate must comply
with the regulations of the Machine Directive in force which
declare the presumed conformity of the automation.
In consideration of this, all the installation, connection,
inspection and maintenance operations of the product
must be performed exclusively by a qualified and
competent technician!
m
CAUTION! Important instructions: keep this manual
for any possible future requirement for maintenance and
disposal of the product.
1.2 - Warnings for installation
• Before beginning the installation procedure, check that this
product is suitable for the intended use. If unsuitable, do NOT
proceed with installation.
Taking into account the hazards which could occur during
installation and product operation, the automation system should
be installed according to the following procedure:
• Ensure there is a system device which is a means of
disconnection from the supply mains. This device must
have a contact separation in all poles which ensures full
disconnection under overvoltage category III conditions.
• All installation and maintenance operations must be carried
out with the automation system switched OFF and the power
supply disconnected. If the disconnection device is not visible
from where the automation system has been installed, a
sign must be attached to it before attempting any work. The
sign should read: "CAUTION! MAINTENANCE WORK IN
PROGRESS".
• The product must be connected to a power supply line
equipped with safety grounding system.
• Take care not to crush, bang, drop or spill any kind of liquid
on the automation system during installation. Do not keep the
product close to sources of heat or open flames. Doing so
may damage it, corrupt it or lead to hazardous situations. If
this were to happen, stop installation immediately and contact
King Gates Customer Service.
• Do not make alterations to the product in any way. Improper
use can only lead to malfunctions. The manufacturer declines
all liability for damage caused by arbitrary modifications to the
product.
20
• This product is not intended for use by people (including
children) with reduced physical, sensory or mental capabilities
or who lack experience and knowledge, unless they have
been given supervision or instruction concerning the use of
the product by a person responsible for their safety.
• The product is not intended as an intruder protection system.
Additional devices must be installed alongside the automation
system to guarantee effective protection.
• Do not allow children to play with the fixed control devices.
Keep remote control devices out of their reach as well.
• The automation system must not be used until it has been
commissioned as described in chapter 5 ("Testing and
commissioning").
• The packing materials of the product must be disposed of in
compliance with local regulations.
1.3 - EU declaration of conformity
The manufacturer V2 S.p.A., headquarters in Corso Principi di
Piemonte 65, 12035, Racconigi (CN), Italy
declare that the products
STARG824NG
conform to the essential requirements established in the following
directives:
• 2014/53/EU (RED Directive))
• 2014/30/UE (EMC Directive))
• 2014/35/UE (Low Voltage Directive)
• RoHS3 2015/863/EU Directive
Racconigi, 01/07/2020
V2 S.p.A. legal representative
Sergio Biancheri