Outputs - Extron electronics Quantum Ultra Series User Manual

Outputs

The Quantum Ultra Series HDMI, HDMI 4K PLUS, and DTP output cards integrate all
inputs to be displayed in a layout that you define using the control software (see the VCS
Help File for information on using the program to set up displays). They also provide
up-scaling of sources.
HDMI outputs
HDMI output cards — These cards provide the final output to a display device.
•
They have four female HDMI A connectors, numbered 1 through 4 from left to right.
Connect up to four HDMI or DVI (with an appropriate adapter) displays to these cards.
Each OUT4HDMI output card can process up to four 2048x1200 signals at 60 Hz. On
each output card, connectors 2 and 4 can be configured to support up to 300 MHz.
This supports two 2560x1600 signals at 60 Hz or two 4096x2160 signals at 30 Hz.
NOTE: If connector 2 on a card is configured to support 300 MHz signals,
connector 1 on the same card is disabled. If connector 4 is configured to
support 300 MHz signals, connector 3 is disabled.
OUTPUTS
Figure 22.
NOTE: Figure 22 shows the standard HDMI output card. The HDMI 4K PLUS
output card appears the same except for the card name, OUT4HDMI 4K PLUS, in
the upper-right corner of its front panel.
HDMI 4K PLUS output cards — (Quantum Ultra II models only) Like the standard
•
HDMI output cards, these cards have four female HDMI A connectors, numbered
1 through 4 from left to right, to which up to four HDMI or DVI (with an appropriate
adapter) displays can be connected.
Unlike the standard HDMI cards, all four outputs on these cards can generate
resolutions with pixel clocks of up to 600 MHz, providing support for resolutions of
4096x2160 at 60 Hz. Audio from sources connected to IN4HDMI 4K PLUS cards
can be embedded onto the HDMI outputs of these cards. No connector disabling is
required to support any resolution.
DTP outputs — Quantum Ultra and Ultra II 610 and 305 only
The DTP cards have four twisted pair outputs on RJ-45 connectors. They also contain an
RS-232/IR control connector for each output, a TP mode switch, and a power connector
providing power over DTP for the four outputs.
OUTPUTS
DTP output connectors
1
TP mode switch
2
Figure 23.
Quantum Ultra Series Videowall Processing Systems • Installation and Configuration
1 2
HDMI Output Card
SIG LINK SIG LINK
DTP POWER
12V
4A MAX
Tx Rx G Tx Rx
OUT OUT
4 4 4
DTP Output Card
3
1 1 1
SIG LINK SIG
Tx Rx G Tx Rx Tx Rx G Tx Rx
OUT OUT
3 3 3
OVER TP control connectors
3
DTP POWER connector
4
QUANTUM OUT4HDMI
4
LINK QUANTUM OUT4DTP
DTP
Tx Rx G Tx Rx
2 2 2
31