Hydraulic Reservoir Cap - Check; Steering Hitch - Tightening - Fayat Group DYNAPAC CC224HF Instruction Manual

Figure. Rear frame front left side
1. Hydraulic reservoir cap
Fig. Steering hitch
1. Nut
144

Hydraulic reservoir cap - Check

Turn up the machine so that the tank cap is accessible
from the left side of the machine.
Unscrew and make sure that the reservoir cap is not
clogged. Air must have unobstructed passage through
the cap in both directions.
1
If passage in either direction is blocked, clean the filter
with a little diesel oil and blow through with
compressed air until the block is removed, or replace
the cap with a new one.

Steering hitch - Tightening

1
The easiest way to identify if you have this type of
steering hitch is that it has a new type of nut (1) at the
top, as shown.
Actual torque (Nm) should be when the machine's
position is straight ahead.
M14 M14
M16 M16
4812159601_H.pdf
Maintenance - 1000h
Wear protective goggles when working with Wear protective goggles when working with
compressed air. compressed air.
Nobody must be allowed near the steering joint Nobody must be allowed near the steering joint
when the engine is running. Risk of being when the engine is running. Risk of being
crushed when the steering is operated. Switch crushed when the steering is operated. Switch
off the engine and activate the parking brake off the engine and activate the parking brake
before lubricating. before lubricating.
174 Nm 174 Nm
270 Nm 270 Nm
2021-01-14