Fayat Group DYNAPAC CC224HF Instruction Manual page 93

Operation
Washing the spreader
When corrosive material has been used the spreader
must be flushed clean with water.
This should also be done when the spreader is not to
be used for a long period.
Adjusting the chain 1
Loosen the four bolts for the bearing housing and turn
it to the correct position, where the chain has a
clearance of approx. 10 mm. Tighten the bolts.
Adjusting the chain 2
Loosen the two nuts, see arrows, for the bearing
housing and turn it to the correct position, where the
chain has a clearance of approx. 10 mm. Tighten the
nuts.
Lubrication
At the start of every season and after every 40 hours
of operation. Once per season is sufficient during
infrequent use.
Lubricate after every season before putting into
storage.
2021-01-14 4812159601_H.pdf
81