Chip Spreader (Optional); Adjusting The Feed Volume - Fayat Group DYNAPAC CC224HF Instruction Manual

A
B
C
Fig. Control panel
1. Switch, Chip spreader
80

Chip spreader (optional)

Chip spreading is started with the switch (1) on the
control panel.
The control has three positions (A, B, C):
1
• A (upper position) = Manual, chip spreader starts directly.
• B (middle) = Off, chip spreader is switched off
• C (lower position) = Auto position, chip spreader starts at
a set speed. (Can be changed via parameter in service
tool on display)

Adjusting the feed volume

The quantity of chips spread per square metre is
adusted by changing the speed of the feed roller.
This setting is made via the display in the menu
"Machine Settings").
Preparations before adjustment / emptying.
Emptying
Empty the spreader by setting it in transport mode
over the required area and by fully opening the lever
on the left-hand side.
4812159601_H.pdf
The machine should be placed on a level surface The machine should be placed on a level surface
with the engine switched off and brake applied. with the engine switched off and brake applied.
Operation
2021-01-14