Figure 21 Copy Window - Secutron MR-2200 Programming Manual

• Manual Restart: Check this to require that the control module not be reset by System
Reset but by Manual Restart. Use of this option requires that there be a Manual Restart
function key assigned to the panel.
• Trigger Manual Restart: Check this option to have a monitor module generate a
Manual Restart when activated. Module Restart must have Non-reporting function.
2.9.9 Pushbuttons
The push buttons located on the right hand side are:
• Exit: Closes the window and returns to the previous window.
• Devices: Opens the Devices Window for the current circuit (Circuits Window only).
• Copy: Copies the circuit/device information, relates and message from another input to
the current input (see Figure 21). The current input does not have to be defined. Relates
cannot be copied between conventional and addressable input points. The Panel ID,
Circuit ID and Device ID (not always shown) list the circuit/device to be copied from.
Marking Transfer Main Definition copies the listed circuit/device type and function to the
current circuit/device. Note: Not all inputs can be copied to all other possible inputs.
Marking Transfer Relates copies the relates from the listed circuit/device relates to the
current one. This may cause some invalid relates. Marking Transfer Message causes the
message to be copied. Marking Transfer Devices (if shown) copies any device
definitions that the listed circuit contains. These devices copy messages and relates as
based on those settings above. There is no checking made at this time as to the validity
of the values copied. Unexpected results can occur if care is not taken. For each
database that is created, a warning about using copy is shown. Marking the check box in
the warning stops the box from appearing again for the database. This option can help
speed up the creation of a database. By completely defining one input, these values can
be copied to all other inputs, making any minor changes that are required after the copy.

Figure 21 Copy Window

• Relate or Trbl Relate: Opens the Relate Window for the current circuit or device. This
allows for the programming of outputs, LEDs, relays and control modules to be operated
when the input goes into alarm. The Relate button displays all output types that are
available depending on the function type of the input. The Trbl Relate button displays
only LEDs that can be related. Note: All panel outputs and control modules to be
operated must be defined before they can be included in the relates of an input.
• Map: Displays and/or updates the Map Window. See section 2.8 Map Window of the
Modul-R Human Interface User Guide.
• Verify List: Displays the Verify List. If there is no Verify List, a requester will appear
asking whether you wish to perform a verification. See section 2.6.5 of the Modul-R
Human Interface User Guide for a full description of the Verify List and its uses.
Editing MHI Databases
39