i
Note:
Key
General Alarm
Automatic
Alarm Signal
Cancel
2.8.18 Dialer Settings
The Dialer Settings dialog (see Figure 13) allows for the programming of various
communications options.
Figure 13 Dialer Settings
st
The 1
, 2
perform the following functions:
•
HEX (B)-simulates the [*] key
•
HEX (C)-simulates the [#] key
•
HEX (D)-forces the panel to search for dial tone; must be first digit of telephone number
•
HEX (E)-forces the panel to pause for 2 seconds
•
HEX (F)-end of telephone number marker
30
Networking is limited to two nodes for ULC applications.
Action
See General Alarm on page 29 for information about this key.
Configure one of the four remaining keys as Automatic Alarm Signal Cancel and
label it as follows:
AUTO ALM SIG CANCEL
TMR CANCELLED
TMR ACTIVE
(yellow)
(green)
Note: This key is optional.
See Automatic Alarm Signal Cancel (Second Stage Inhibit) on page 28 for
information about this key.
nd
rd
and 3
Telephone Numbers can be up to 32 digits. Special digits may be used to
Editing MHI Databases