Mounting In The Beam Tower - Optex AX-100 TFRi Installation Instructions Manual

Fix the chassis on the pole.
4
Detector 2
U-bracket
M4×30 screw
(supplied)
(supplied)
Caution
After mounting the chassis, wiggle the tamper bushing
with your thumb and forefinger to ensure the tamper
works properly.
Refer to sec. "3-1" steps 3 through 4 to install the wireless
5
transmitters and batteries in the back box, and then install the
back box on the chassis.
Tighten the
back box lock screw.
Mounting inside optional beam tower.
Detector 1
M4×30 screw
(supplied)
-5-

3-3 MOUNTING IN THE BEAM TOWER

Remove the cover from the detector.
1
Loosen the main unit fixing screw and remove the main unit
2
from the back box.
Loosen the
main unit fixing screw.
Caution
Cables are connected between the back box and the
main unit. Do not exert an excessive amount of force
on the cables. Handle the main unit with care.
Remove the harness retainer plate.
3
Main unit
Harness retainer
plate (sticker)
Open the wiring hole in the top of the main unit using pliers.
4
Wiring hole
Remove the chassis from the back box.
5
Loosen the
back box lock screw.